DIY Heart Pattern Bracelet with Acrylic Beads and Glass Beads

Hello, guys. Happy to see you here. Today I am going to show you a tutorial on how to make a heart bracelet with different kinds of beads, do you have any interest? Then please follow me to see the details below. Hope you will like it.

Supplies needed for heart pattern bracelet making:

23mm Handmade Blue Lampwork Beads
10mm Blue Glass Beads
4mm Abacus Acrylic Beads
1.5mm Silver Aluminum Wire
Iron Jump Rings
Iron Twisted Chains
Iron Eye Pins
0.3mm Copper Wire
Round Nose Plier
Side Cutting Plier
Long Nose Plier
Scissors

Step 1: make the wire wrapped heart pattern

Firstly, cut off a piece of 1.5mm aluminum wire about 8cm, then make a loop at two ends.

Secondly, twist the wire into a heart shape, then twist the bottom into a small angel with jewelry plier.

Thirdly, make another same heart pattern with the same steps.  

Step 2: add the beads onto the heart pattern

Firstly, cut off a piece of 0.3mm cooper wire and slide a 4mm acrylic bead onto it, then wrap the wire around the heart shape.

Secondly, continue to slide the acrylic beads onto the cooper wire one by one and wrap the wire around the heart shape until half of the pattern is covered.

Thirdly, add the beads on another heart pattern.

Fourthly, slide a lampwork bead onto a headpin, then make a simple loop. Then connect two heart patterns with this beaded dangle.

Step 3: finish this heart bracelet making

Firstly, slide two blue glass beads onto two headpins respectively, then make a simple at the end.

Secondly, add the two glass beaded dangles to two heart pattern, like this picture shows.

Thirdly, cut off 2 pieces of chains and connect them on the two sides, then connect them with a lobster claw and a jump ring.  

Then this heart bracelet has been finished!

Do you like this heart beaded bracelet? Please let me know if you have any question about this bracelet making. Then have a nice try! See you next time~