Elegant Jewelry Beads and Accessories

Tuesday, 22 December 2015

DIY Wire Beaded Bangle Bracelet within Ten Minutes

Hello, guys. Merry Christmas! How is everything going? Do you often wear bangle bracelet? Today I will show you a tutorial on how to make wire bangle bracelet with acrylic beads and we can finish this project within ten minutes. Just prepare some jewelry making supplies and then follow this article if you don’t believe it. Let’s start!
Supplies needed in making wire beaded bangle bracelet:
1.5MM Aluminum Wire
0.3MM Copper Wire
10MM Cyan Acrylic Beads
Jewelry Pliers
Step 1: prepare wire bangle
Firstly, trim off aluminum wire about 50cm length and make a simple loop at the end.
Secondly, cut off another two pieces of aluminum wire about 40cm length, then put them on the table just as picture shows.
Thirdly, trim off copper wire about 20cm and wrap it around the three pieces of aluminum wire to fix them together. Then cut off extra cooper wire.
Step 2: braid the wire bracelet
Firstly, put the right wire to the middle part and put the left wire to the new middle part, then repeat the steps to braid the wire until the braided wire is about 7cm.
Secondly, slide an acrylic bead onto the middle wire and continue the wire as before.
Thirdly, slide another 4 acrylic beads according to the same way.
Step 3: finish the bangle bracelet
Firstly, continue to braid another 7cm wire and then wrap the end with cooper wire to fix them.
Secondly, cut off the extra wire and make an “s” with aluminum wire.
Then it is finished! A wire beaded bangle bracelet is done.
Now we have finished the bracelet, do you like your own craft? This design of wire bangle is special that wire wraps the acrylic bead, so it looks amazing! Wire jewelry is always attractive for me then I often try to make
different kinds of wire accessories. Do you also want to try it?

No comments:

Post a Comment